Home > News > Content

What Should I Pay Attention To When Using A DLP 3D Printer For The First Time?

Jul 28, 2020

17829

DLP 3D printer is a new type of printing equipment. It has many advantages. Its use has rapidly improved the printing effect. When everyone uses DLP 3D printer for the first time, there are many things to pay attention to. Today Rhenium Saizhizhi will give you a specific introduction to what you should pay attention to when using a DLP 3D printer for the first time.

1. When you use a DLP 3D printer for the first time, to prevent the failure of the first printing, you must do a comprehensive inspection before printing. One is to see if the Z axis is working properly, and then to see if the platform is
 It is not attached to the curing screen, the third is to see if the UV light is displayed normally.

2. When using it, first insert the U disk into the USB port on the front of the DLP 3D printer, then put on gloves and a mask, and slowly pour the resin into the trough. The resin in the feed tank should not be larger than the level scale of 15 mm. After selecting the model, you can start printing. During the printing process, close the top cover to prevent direct sunlight, and to ensure that the table top is flat and free from shaking.

3. During the printing process, if you find that the poured numbers cannot support the completion of the printed model, you can click the pause button. After the z-axis rises, slowly add resin to the trough, and then click to print.
 Then the Z axis will be lowered and printing will continue.

4. After printing is completed, when the residual resin on the platform no longer drips, loosen the fixed knob on the platform and remove the platform.
 Use tools to shovel down the model and use 90% alcohol to clean it.

When you use a DLP 3D printer for the first time, you need to pay attention to the above content, especially to do a good job of checking before printing to see if there are any abnormalities, if the printing fails or the curing is incomplete, The resin in the hopper may have solid residues, so after each printing is completed, the resin in the hopper needs to be filtered using a funnel, and then stored in a sealed tank.